Car Stereo Installation Simple Methods To Follow

It is always ideal to install stereos inside our cars. These devices are just part of vehicles so drivers will never get bored while driving. Listening to music is always a great answer to wash out boredom.


If you wish to install a new car audio then you must be keen with the procedure. With the help of this worthwhile page, an accurate car stereo installation is then perceived. Though you may contact professional installers to help you with this task but working on your own is actually easy, only when you are definite and ready with your decision.

When working on your own, you need to be definite with the tools needed for the job. For this specific task, collecting accurate pieces must be minded. What you need to grasp in here are DIN tools, heat gun, wire cutters, wire stripper, Phillips screwdriver, soldering iron, flat blade screwdriver, retaining clip remover, and heat shrink tubing.

Start your way by removing the factory stereo. It is always appropriate to pay close attention to what procedure is given for this certain task. If you are troubled removing it then you may spend some time doing a wide research reflecting on how to do this task. The Internet can greatly help you with that.

When the latter matter is done then you may now begin to wire the audio. For the connection option, be clear in linking the wires together. Use the crimp connector so to crimp the wires together. There are actually various types of these connectors which commonly include butt connectors, bullet connectors, and crimp caps.

Soldering follows next. This exact method usually creates a permanent and professional connection which can definitely ensure maximum current transfer. Using a heat gun and a heat shrinking tubing so to insulate the soldered assembly quickly is the best. You must never ever tap the settled wires together as it will only expose it.

You need to be immediate and clear in installing power and ground wires. As for power wires, you will settle on constant or switched power. As for the ground cable, a good connection is completely important with this measure. If you are not using a wiring harness then you may seek for a screw, a bolt, or a wire which usually contacts the bare metal of the chassis of your automobile.

To install the new device, you need to acquire a mounting kit in here. When the dash opening is totally prepared to sink in the new device then do the job appropriately. Just by simply sliding the stereo right into the opening and fastening it down, a thorough work is then completed. Just be sure to check how the stereo works by turning it on and trying each source. If adjustments are needed then better be keen in balancing and fading its settings.


It is always vital to install a back strap in here. A mounting bracket can be used up by this part. Though it is not necessary to have this bracket but this material is actually useful to support the stereo rightly situated on the dash. But aside from that, it can also help in reducing vibration.

Leave a Comment

Your email address will not be published. Required fields are marked *